1-15
T O R Q U E C E L L I N S T A L L A T I O N
Replacing the Covers
Version 2
Torque Cell Installation Guide for Model 250i/250iP DynoWare RT Dynammometers
4
Starting from the back of the dyno, slide the carriage under the carriage clamps.
5
Slide the carriage screw, bearing bracket, and the hand wheel toward the nut block
until the carriage screw is touching the nut block.
6
Using the hand wheel, or the power carriage, screw the carriage through the nut
block and into the screw support bracket.
7
Secure the bearing bracket to the carriage using four screws removed earlier.
Figure 1-14: Replace the Tire Carriage
TC080
hand wheel
carriage screw
screws
carriage clamp
tire carriage
bearing
bracket
nut block
