6
ILH800EN2
SAFETY INSTRUCTIONS
Working with the hydraulic system
Regular maintenance of the hydraulic system is
important. Minor damage or a split hose or cou-
pling can have devastating consequences. Bear
in mind that the hydraulic hoses are made of
rubber and can deteriorate with age, which can
result in splitting. In all cases of uncertainty with
regard to durability or wear, replace the hoses
with new original hoses from Dynapac.
Working with battery
The battery contains poisonous and corrosive
sulphuric acid. Wear protective glasses and
avoid getting acid on your skin, clothes or on the
machines. If you get sulphuric acid on yourself,
rinse the skin with water. If you get acid in your
eyes, rinse them with water for at least 15 min-
utes and seek immediate medical treatment. The
gas that is emitted by the battery is explosive.
When fitting or replacing a battery, always take
care so that you do not short- circuit the battery
poles.
Repair
Never use a machine that is damaged. Qualified
repair work requires trained personnel, please
contact your nearest authorized workshop.
Extinguishing fires
If there is a fire in or on the machine, it is best
to use an ABE-class fire extinguisher.
However, a BE-class CO2 extinguisher is
also suitable.
Special safety instructions for Radio
Remote Controlled units
Even if you are accustomed to working with
radio control systems, read these operating
instructions carefully before using this
equipment. Only this document contains the
latest information relating to your Dynapac
radio control system.
For explanatory notes on obtaining an
operating permit please refer to registration
documents enclosed in the appendix of this
operating instruction. Observe all applicable
work-safety and accident prevention
regulations carefully. Only fully trained,
authorized personnel may use the Dynapac
radio control equipment. Components, etc.
built in to the Dynapac equipment for safety
purposes must be regularly inspected.
If the Dynapac radio control unit develops a
fault, it must be shut down immediately. The
transmitter should be switched off with the
start/stop switch. The connecting cable must
be disconnected at the receiver from the
connecting socket (terminal) of the unit to be
controlled. The repair of the equipment must
not be carried out other than by Dynapac or an
Dynapac authorized technician.
Failure to observe these recommendations will
put both you yourself and others at risk. Under
these circumstances, Dynapac rescinds the
guarantee and any other form of liability. This
radio control unit is designed exclusively for
the control of construction machines and
industrial plants. Only under these conditions
are the safety systems (start/stop switch, zero
setting) fully effective. No other form of use is
permitted.
Any non-observance of this condition will
relieve Dynapac of all liability.
