16
ILH800EN2
OPERATION – RADIO REMOTE CONTROL UNIT
Receiver
The receiver is fitted in the machine under the rear
plastic hood. It is equipped with an antenna, display
and integrated battery charger for the transmitter
batteries.
The charging time for the transmitter battery in the
receiver is 1 hour.
The display shows:
Battery voltage, machine:
U:XX. X
Temp. in hydraulic reservoir (°C):
XX:°C
Temp. in hydraulic reservoir (°F):
XX:°F
Aggregate operating time, diesel engine: XXXXYh
(Y is used if the number of operating hours exceeds
9999, otherwise Y is blank).
Error messages:
Err: XX
The display shows first the battery voltage and then the
other values, rolling. To browse, press the right
frequency-change button (8) on the transmitter (with
the receiver in operating mode).
The display also shows several error codes (
Err: XX
):
Err: 01:
Low engine oil pressure.
Measure: Check/top off oil.
Err: 02:
High hydraulic temperature.
Measure: Allow machine to cool. Check the drive
system/eccentric elements if the ambient temperature
is extremely high.
Err: 10:
Radio contact broken during operation.
Measure: Change frequency if this occurs often.
Battery charger (optional)
A steady green light indicates that the charger is ready
for charging. Place the battery in the charger. If the
battery is completely discharged, the yellow LED
flashes slowly during the pre-charge. A steady yellow
light indicates that the battery is being charged. The
battery is fully charged when the yellow LED flashes
quickly. Charging time is 3 to 5 hours. The battery will
not be damaged if left in the charger when fully
charged.
Use the charger only in a dry room with min.
and max. temperature 0–40°C. A charged
battery is concentrated energy. Never keep a
battery where it can be short-circuited.
Battery charger
Receiver
L000325A
L000326A
WARNING
