Dynapac DFP10D, Operating Instructions And Maintenance Instructions

Page: 87 / 98

4. Unscrew the filler and check the oil level; top up if necessary.
ð
The oil level must reach the bottom edge of the filler.
5. Clean the filler screw and screw it in with a low-strength
sealing agent (e.g. spare parts number: DL 009 700 16).
6. Fasten the filler, tightening torque: 40 Nm (30 ft
·
lbf).
8.8.5 Measures prior to extended shut-down period
8.8.5.1 Measures before shutting down
If the machine is shut down for a longer period of time, e.g. winter
season, the following work must be carried out:
1. Clean the machine thoroughly.
2. After shutting down store the machine under cover in a dry
and well ventilated room.
3. Repair damaged paint; preserve bare areas thoroughly with
anti-corrosive agent.
4. Clean the water separator.
5. Fill the fuel tank with diesel fuel to prevent the formation of
condensation water in the tank.
6. Change the engine oil and clean the oil filter.
7. Change the fuel filter.
8. Protect the cooled down engine against dust and moisture.
8.8.5.2 Measures before restarting
1. Replace the fuel filter.
2. Replace the air filter.
3. Change the engine oil and clean the oil filter.
4. Check cables, hoses and lines for cracks and leaks.
5. Start the engine and run it for 15 to 30 minutes with idle
speed.
6. Check the oil levels.
7. Clean the machine thoroughly.
B-834-0381
Fig. 86
Maintenance – As required
DFP10D 87