Dynapac DFP10D, Operating Instructions And Maintenance Instructions

Page: 86 / 98

3.
NOTICE!
Electric components can be damaged by
water entering into the system!
– Do not guide the water jet directly into the
cooling air openings of the recoil starter,
into the dry air filter or onto electrical
equipment.
Clean the machine with a water jet.
4. Warm up the engine for a while to avoid corrosion.
8.8.3 Cleaning the water spraying system
1. Park the machine safely Ä Chapter 6.4 ‘Parking the machine
in secured condition’ on page 57 .
2. Remove the cap (1).
3. Remove the rubber caps (3) from the spray tube.
4. Open shut-off valve (2) and drain off all water.
5. Flush the water tank with a strong water jet, until all dirt has
run out.
6. Plug the rubber caps back on the spray tube.
7. Fill the water tank with clean water and close the cap.
8.8.4 Checking the oil level in the exciter housing
NOTICE!
Components may get damaged!
– Use only oil of the permitted specification
Ä Chapter 8.3 ‘List of fuels and lubricants’
on page 67 .
– Do not use low-ash engine oils for the exciter
shaft housing.
Protective equipment: n Working clothes
n
Safety shoes
n Protective gloves
1. Drive the machine onto horizontal, level, firm ground.
2. Park the machine safely
Ä
Chapter 6.4 ‘Parking the machine
in secured condition’ on page 57 .
3. Allow the machine to cool down.
Fig. 84
3
1
2
B-834-0299
Fig. 85
Maintenance – As required
DFP10D 86