17
CP142 M142EN1
EVERY 50 HOURS OF OPERATION (Weekly)
Front suspension
– Lubrication
Lubrication nipples to the steering bearing is located
under the rotating suspension flange.
Lubricate the steering bearing with 2 strokes of the
grease gun.
The suspension tap (2) must not rotate. Check
if the lock plate is missing or damage.
Grease the front suspension main pin (2) with 3
strokes of the grease gun.
1
Fig. 19 Steering joint, assembly
1. Steering bearing
2. Suspension tap
3. Grease fitting
4. Lock plate
2
3
Front oscillation shaft
– Lubrication
Fig. 20 Oscilleringsaxel
Wipe all the fittings clean from dirt and grease.
Lubricate each fitting with five strokes of the grease
gun. Make sure that grease enters the pin.
If grease does not enter the pin it may be necessary to
relieve the articulated joint with a jack and repeat the
greasing procedure.
Steering cylinder
– Lubrication
Fig. 21 Steering cylinder
Wipe all the fittings clean from dirt and grease.
Lubricate each fitting with two strokes of the grease
gun.
Leave a little grease on the fittings after greasing. This
will prevent dirt from entering the fittings.
4
Summary of Contents for CP142
Page 2: ...19 ILF015WO1...
Page 29: ...19 ILF015WO1...
