Dynapac CC7200, Instruction Manual

Page: 52 / 101

Operation
4812158801_E.pdf 2018-04-03
Starting
Starting the engine
Fig. Instrument panel
1. Emergency stop
2. Speed switch
3. Ignition lock
4. Forward/reverse lever
5. Warning lamp, brakes
6. Warning lamp, engine oil pressure
7. Warning lamp, charging
8. Preheating lamp
9. Parking brake knob
10. Vibration switch
1
9
2 3 10
8
4
7
5
6
The steering column must be in the locked
position in relation to the driver's seat from which
you are intending to operate the machine, and the
driver must be sitting on this driver's seat in order
to start and operate the machine. The steering column must be in the locked
position in relation to the driver's seat from which
you are intending to operate the machine, and the
driver must be sitting on this driver's seat in order
to start and operate the machine.
Make sure that the emergency stop button (1) is pulled
out and the parking brake (9) is activated.
Set the forward/reverse lever (4) in neutral. The
engine can only be started when the lever is in neutral.
Set the engine speed control (2) to idling.
Set the vibration switch (10) for manual/automatic
vibration in the mid position (position 0).
Turn the ignition key (3) to the right to the first position.
The preheating lamp (8) lights on the indicator panel.
When the lamp goes out, turn the knob to the start
position and release immediately the engine starts.
This particularly important when starting the machine
from cold.
Do not run the starter motor for too long. If the
engine does not start immediately, wait a minute
or so before trying again. Do not run the starter motor for too long. If the
engine does not start immediately, wait a minute
or so before trying again.
Starting gas is not to be used. Starting gas is not to be used.
If the starter motor is activated for 30 seconds or more
without the engine starting, the starter motor will be
locked, preventing activation during a cooling process.
Let the engine idle for a few minutes to warm, longer if
the ambient temperature is below +10°C (50°F).
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning. Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
While the engine is warming up, check that the
warning lamps for oil pressure (6) and charging (7) are
turned off.
44