Dynapac CC1000, Instruction Manual

Page: 109 / 116

Maintenance - 2000h
4812160801_D.pdf 2018-12-17
Check - Coolant system
Figure. Cooling water container
1. Filler cap
2. Level marking
1
2
Check that all hoses/hose connectors are intact and
tight. Fill with coolant as specified in the lubricants
specification.
Take great care when opening the radiator cap
while the engine is hot. Wear protective gloves and
goggles. Take great care when opening the radiator cap
while the engine is hot. Wear protective gloves and
goggles.
Also check the freezing point. Change the coolant
every other year. Also check the freezing point. Change the coolant
every other year.
Drum - Checking the oil level
Fig. Drum drive side
1. Oil plug
1
Park the roller on a level surface, and drive the roller
slowly until the oil plug (1) is in the middle of the
semicircle shaped notch in the drum suspension.
Switch off the engine, disconnect the power and
push in the emergency stop button. Switch off the engine, disconnect the power and
push in the emergency stop button.
Unscrew the plug and check that the oil level reaches
the hole’s lower edge. If necessary, top off with fresh
transmission fluid. See under the heading lubricants
for correct fluid grade.
Clean the magnetic oil plug (1) from any metallic
residue, and refit the plug.
101