Dynapac CC1000, Instruction Manual

Page: 94 / 116

Maintenance measures - 500 h
4812160801_D.pdf 2018-12-17
Engine oil and oil filter - Change
Fig. Engine compartment left side
1. Drain hose
2. Plug
3. Filler cap
4. Oil filter
1
2
3
4
Run the engine until it is warm before draining the oil .
Switch off the engine and push in the emergency
brake button. Switch off the engine and push in the emergency
brake button.
Take great care when draining fluids and oils.
Wear protective gloves and goggles. Take great care when draining fluids and oils.
Wear protective gloves and goggles.
Set a container which can hold at least 5 liters (1,3
gal) under the drain plug (2).
Undo the oil filler cap (3), and undo the plug (2) in the
end of the drain hose (1). Let all the engine oil flow out.
Deliver the drained oil to special waste handling. Deliver the drained oil to special waste handling.
Refer to the engine manual for detailed
instructions when changing oil and filters. Refer to the engine manual for detailed
instructions when changing oil and filters.
Remove the oil filter (4) and fit a new filter.
Collect any spillage.
Fit the drain plug (2) to the end of the hose.
Fill with fresh engine oil. See under the heading
lubricants, for the correct oil grade. Fit the filler cap (3)
and check that the oil level is correct using the dipstick.
Start the engine and allow it to idle for a few minutes.
During this time, check around the oil filter for leaks.
Switch off the engine, wait for a minute or so and then
check the oil level. Top up with more oil if necessary.
86