24
CA152 M152EN3
EVERY 1000 HOURS OF OPERATION (Every six months)
1
1
1
2
2
Rear axle planetary gears
– Oil change
Fig. 42 Planetary gear/filling position
1. Plug
Fig. 41 Planetary gear/drainage position
1. Plug
Position the roller with the plug (1) at its lowest position.
Wipe clean, unscrew the plug (1) and drain the oil into a
suitable receptacle. The volume is about 2 litres (2.1 qts).
Save the oil and deposit it in an approved
manner.
Position the roller with the plug at 9 o’clock.
Fill with oil to lower edge of level hole. Use transmis-
sion oil. See lubricant specification.
Clean the plug and screw back in.
Change the oil in the same way as the other planetary
gears of the rear axle.
Fig. 43 Cab
1. Fresh air filter
2. Screw (x2)
Fresh air filter – Replacement
Use a stepladder to reach the filter (1).
As an alternative the filter can be reached
via the cab window on the right side.
Loosen the two screws (2) at the rear of the cab roof.
Take down the whole holder and remove the filter
insert.
Replace with a new filter.
It may be necessary to replace the filter more often if
the machine is used in a dusty environment.
Summary of Contents for CA152D
Page 2: ...19 ILF015WO1...
