16
CA152A M152AEN2
1
1
2
Steering cylinder
– Lubrication
EVERY 50 OPERATING HOURS (WEEKLY)
Steering joint and steering
cylinder – Lubrication
Fig. 19 Steering joint, left side
Steering joint
– Lubrication
Fig. 21 Steering cylinder
2. Lubricating nipples, cylinder
brackets (x2)
Fig. 20 Steering joint, left side
1. Lubricating nipples,
steering joint (x4)
Wipe nipples clean from dirt and grease.
Lubricate each nipple (2) with three strokes of the grease gun.
Allow a little grease to remain on the nipples after
greasing. This will prevent contaminants from entering
the nipples.
Place the roller on a level surface. Switch the
engine off and push in the reserve/parking
brake knob for all checking and adjustments
on the roller, unless otherwise specified.
Allow no one to get near the steering joint
when the engine is running. Danger of
being crushed when steering is operated.
Push the reserve/parking brake knob be-
fore lubricating.
Turn the steering wheel fully to the right to gain access
to all six lubricating nipples on the left side.
Use grease recommended in Lubricant Speci-
fication.
Wipe all the nipples clean from dirt and grease.
Lubricate each nipple (1) with five strokes of the grease
gun. Make sure that grease penetrates the bearings.
If grease does not penetrate through the bearings, it
may be necessary to relieve the load on the articulated
joint with a hydraulic jack and then repeat the greasing
process.
Summary of Contents for CA152A
Page 2: ...19 ILF015WO1...
