10.7 Electromagnetic compatibility
Dynamic Controls' electronic controllers have been tested on typical, representative vehicles to
confirm compliance with the following appropriate EMC standards:
USA: ANSI/RESNA WC-2:2009 Sec 21
Europe: EN12184:2009 Sec 9.1
National and international directives require confirmation of compliance on particular vehicles. Since
EMC is dependent on a particular installation, each variation must be tested. The guidelines in this
section are written to assist with meeting EMC requirements in general.
10.7.1 Minimising emissions
To minimise emissions and to maximise the immunity to radiated fields and ESD, follow the General
Wiring Recommendations in the DX System Manual.
10.8 Environmental statement
Dynamic Controls confirms that the product variants specified in this manual, as sub-assemblies of
electronic and electrical equipment supplied for further integration by a medical device manufacturer,
conform to applicable requirements of Directive 2011/65/EU, recast of Directive 2002/95/EC -
Restriction of the use of certain Hazardous Substances in electrical and electronic equipment.
This product has been supplied from an environmentally aware manufacturer. Please be
environmentally responsible and recycle this product at the end of its life through your
local recycling facility. This product may contain substances that could be harmful to the
environment if disposed of into a landfill.
See also
:
http://www.dynamiccontrols.com/designers-and-manufacturers/compliance
10.9 Symbols and labelling
10.9.1 Product label
The product label is located at the base of
the compact remote module, as shown in
The product label details:
l
Dynamic Controls' website address
l
The product's part number
l
The product's bar code
l
The product's serial number
l
Dynamic Controls' 'dynamic' logo
Figure 36: Location of product and other labels
GBK65701 DX2 Compact Remote Modules
Installation Manual Issue 1
Appendices - Page 49