M
T
Setting
Description
Drive Profiles
Turning Speed @
Maximum
Sets the maximum turning speed for the selected profile when the
selected joystick is pushed fully left or fully right. Set to a low value
for a slower controlled wheelchair drive performance particularly
when driving indoors.
Turning Speed @
Minimum
Sets the maximum turning speed of the chair with the joystick fully
sideways and either Chair Speed set to minimum or the DCI speed
pot at minimum.
Turning
Acceleration*
Sets the maximum turning acceleration rate. Set to lower values for
soft and gentle wheelchair drive performance.
Turning
Deceleration*
Sets the maximum turning deceleration rate. Set to lower values for
soft and gentle wheelchair drive performance. This value must
always be greater than the programmed "Turning Acceleration".
*Note:
The Speed Damping and Turn Damping parameters are ignored by
the DX-GB.
In a standard DX system, Speed Damping and Turn Damping are
applied to reduce the acceleration or deceleration when the
powerchair almost reaches the desired speed. This provides a
smooth transition between acceleration and end speed.
The DX-GB drive algorithm does not use Speed Damping and Turn
Damping, it uses its own parameters. Refer to section 3.2.2: DX-GB
Specific Parameters.
23
