Dynamatic 015-000248-2002, Instruction Manual

Page: 49 / 68

EC-2000-CES MANUAL
49

FAULT 212 Reverse Command without Inch or Micro Inch
o
If Reverse is enabled and neither inch or Micro Inch are enabled and the clutch is
engaged, after a programed time the control will fault
o
Time Parameter Group H Item 6

FAULT 213 Missing High Enable
o
During Starting if the high enable is not closed within the programed amount of time
this fault will be set.
o
Time - Parameter Group H Item 2

FAULT 218 Clutch On Input without Clutch Contactor
o
If the two enables are closed and clutch on enabled during starting or running and the
clutch contactor is opened or remains open for the programmed time this fault is set.
o
Time = Parameter Group H Item 2 (Starting) Item 3 (Running)

FAULT 219 Inputs Present on Startup or at Fault Reset
o
If any enable inputs are closed at control startup or on fault reset this fault is set. Not
Programmable

FAULT 223 Clutch Contactor Removed Late
o
The clutch contactor needs a time delay on stopping to dissipate clutch current. This
delay is programmable, but usually controlled by the clutch controller. If the contactor
remains closed after the programmed setting, this fault will be set.
o
This control has a setting for clutch delay under brake performance.
o
Time = Parameter Group H Item 4

FAULT 224 Top Stop Out Of Range
o
When operating in single stroke mode, if the control fails to perform a top stop within
the programmable degree range +_ degrees, this fault is set.
o
Degree error = Parameter Group I Item 1
o
Top Stop Degrees = Parameter Group F, Item 17

FAULT 225 Clutch Contactor Removed Early
o
The clutch contactor needs a time delay on stopping to dissipate clutch current. This
delay is programmable, but usually controlled by the clutch controller. If the contactor
opens before the programmed setting, this fault will be set.
o
This control has a setting for clutch delay under brake performance.
o
Time = Parameter Group H Item 5

FAULT 226 Stop Angle Reached before Creep Speed Attained
o
If the control is in single stroke mode it will reduce speed to the creep speed when it
passes the creep angle. If it doesn’t get to creep speed prior to reaching the stop angle
this fault is set.
o
Creep Angle = Parameter Group F, Item 15, Creep Speed = Parameter Group F, Item 16,
Stop Angle = Parameter Group F, Item 17.

FAULT 227 Enable Before Clutch Cool Down Expired
o
If the control faults out on clutch over current or clutch current on too long, control
operation is not possible until the cool down time expires
o
Time = Parameter Group H, Item 14

FAULT 228 Enable Before Brake Cool Down Expired
o
If the control faults out on brake over current or brake current on too long, control
operation is not possible until the cool down time expires