GENERAL ALARM
CAUTION: The launch of an alarm does not depend on a call station (kit)
priority setting it had been activated from. Launching an
alarm is possible from any microphone terminal at any time,
even when the system is in stand-by mode. A running alarm
is optically and occasionally also acoustically indicated at
every call station (kit)
A general alarm signal is always transmitted to all lines of the entire
installation.
Activating the covered ALARM button launches the assigned alarm. The
corresponding alarm LED output is activated during the transmission of the
alarm signal. The alarm has priority over any announcement or other event,
except for those that were ignited from the directing call station.
Activating the ESC input cancels the alarm.
SELECTIVE ALARM
CAUTION: The launch of an alarm does not depend on a call station’s
(kit) priority setting it had been activated from. Launching an
alarm is possible from any microphone terminal at any time,
even when the system is in stand-by mode. A running alarm
is optically and occasionally also acoustically indicated at
every call station (kit.)
A selective alarm allows transmitting alarm signals into selected lines. Similar
to the procedure for making a selective call you first have to select areas or
groups to which the alarm signal shall be transmitted. Afterwards, activating
the covered ALARM key input starts the selective alarm. The corresponding
ALARM LED output lights during the transmission of an alarm. Already now,
you are able to enter the lines for the following alarm.
Activating the ESC button cancels the alarm.
CANCELING SIGNALS
Activating the Dow n_ K input cancels alarms, chime signals and text message
transmissions. The functionality of the ESC button (e.g. priority, local
events) is configurable via IRIS-Net. Events can only be terminated at the
call station kit they were launched from with the exception of the directing
terminal (call station with the highest priority). Through the directing station
it is possible to cancel any signal in progress.
SYSTEM ON / OFF
The Up_K button switches a PROMATRIX 8000 system on or off. Mostly, it is
not intended that any call station k i t be provided with the possibility to do
so. However, this function can be programmed via IRIS-Net.
When the system is in stand-by mode, the up LED is deactivated. Activating
the up contact turns the PROMATRIX 8000 system’s power on which can
take several seconds, while the corresponding up LED output is toggling
on/off. Once the system is ready for operation, the u p LED output is
activated continuously (which also applies for all call stations (kit) of the
entire installation).
