3.2
Operation mode
After power on the call station kit is in
operation mode
. For configuring the
call station kit the
setup mode
is used. Several key functions differ between
setup mode and operation mode, see following table.
Operation mode (default configuration)
Setup mode
Up_K
(
↑
Up key
)
The U P input turns the system‘s power on or off.
Turning the power on can take several seconds. The
LED output toggles on and off while the system boots.
The UP
LED output is steadily when the system is
operational. To prevent inadvertent erroneous
operating closing the up input for at least 3 seconds
is necessary when turning the power off. It is also
possible to prohibit the operation of the up
input during
the configuration procedure.
In setup mode this
input is used to select
the previous parameter/
menu item.
ESC_K
( ESC key
)
Closing the ESC input confirms an error in the
PROMATRIX 8000 system and cancels an output alarm
output signal.
This input is used to
cancel the editing of a
parameter or to move
upwards in the menu
tree.
Down_K
(
↓
Down key
)
Closing the Down input stops a currently running audio
signal (chime, alarm, text). Use the IRIS-Net software
for configuring the input functionality in detail.
In setup mode this
input is used to select
the next parameter/menu
item.
DEL_K
( DEL key
)
The DEL input allows the selection of all programmed
areas at once for transmitting messages, chime or
alarm signals, vocal messages, or to assign programs.
On time pressing selects all areas. The corresponding
selection LEDs and the DEL LED outputs are set.
Subsequent closing cancels (clears) the selection.
Following modes are available in the IRIS-Net software
for this input:
•
Toggle between all and clear
•
Select All
•
Deselect All
Deletes the currently
selected parameter.
Return_K
(
↵
Enter Key)
The enter input activates a message for pre-selected
areas or groups. The LED output toggles on and off when
one or several areas are busy or when an event with
higher priority setting interrupts the output message.
The optional toggle mode of the key is configured
via IRIS-Net.
Confirms the parameter
change or selects the
highlighted menu item.
