Dynacord DPS260, Owner'S Manual

Page: 21 / 56

Output Gain Reduction Meters
Each output channel has a four-segment gain reduction meter that
shows the effect of the output channel Limiter on output level; from
0dBu to -12dBu. Output limiting can be bypassed by entering Edit mode,
selecting Output Channel Limiter and selecting a limiter threshold of +21
dBu (8.691V) or turning the Bypass parameter to “On”.
Output Channel Mute Buttons
Each output channel has a lighted Mute button. Pressing the Mute button turns off
the output of that channel. The button lights red as an alert. Press the Mute
button again to restore the output channel’s signal.
Mute Mute Mute Mute Mute Mute
Output Channel Function Indicators
Each output channel has a four-segment function display for informational
purposes only. For any given configuration possible with the DSP 260, an
output channel may be identified as a sub, low, low/mid, mid, mid/hi, hi or
full range output. One or two adjacent LED’s are displayed to indicate all
possible output bandpasses. (Full range is indicated by no lit LED’s.)
Preset Recall
The DSP 260 preset memory
provides 60 factory program presets
and can store up to 20 user presets.
Recall
(F01-F60, U01–U20) Factory presets have been
designed to represent common system
configurations utilizing Dynacord loudspeaker
systems. User presets allow you to accommodate other system configurations and
/ or loudspeaker systems.
To recall a preset, press the front panel Recall
button. The display switches to the Recall
Preset screen and displays the next in a list of
available presets in memory. Using the Value Up
and Down buttons, select the preset to be
recalled. Valid presets will display the preset
name. Empty presets will display a “?”.
Select a valid preset and press Recall again. The display will prompt, “Recall
Preset? Press Recall”. Press Recall a third time to confirm and load the new
preset.
If the preset you are recalling is based on a
configuration different from that of the current
preset, the display will prompt, “Changing
config can damage speakers”, to remind you
that the new preset may not be appropriate for
your system as it is currently connected. Press
Recall again to confirm and load the new preset.
21
Owners Manual