Installing
the
Panel
Assembly
Install the panel assembly according to the following procedures:
1.
Seat and adhere the Hinges in the correct position on the LCD cover assembly as shown
in Figure 4.17-1 (Tighten the six M2×2.5 screws).
2.
Seat and adhere the antennas in the correct position on the LCD cover assembly as shown
in Figure 4.17-1 (. (Tighten the two M2×3.0 screws)
3.
Seat and adhere the Camera in the correct position on the LCD cover assembly as shown
in Figure 4.16-1
4.
Seat and adhere the Antenna module in the correct position on the LCD cover assembly as shown
in Figure 4.15-1
5.
Place the panel assembly upside down so that the bottom is facing up.
6.
Connect the EDP cable to the panel connector and lock it with lock bar, then adhere the mylar over
the connector to secure it in place as shown in Figure 4.14-2
7.
Connect the EDP cable FFC to the camera FPC board connector as shown in Figure 4.14-3
8.
Pull up the blue release paper of Panel Adhesive from LCD cover as shown in Figure 4.14-4
9.
Rotate the panel right-side up and use 0.5mm Mylar between LCD cover and Panel to seat it in
the correct position as shown in
Figure 4.14-5
