Installing
the
thermal
module
Install the thermal Cu-plate according to the following procedures:
1.
Seat the fan in the correct position on the logic upper assembly and insert the fan connector
□
,1 and tuck the fan
cable into the fan hook
□
,2. as shown in
Figure
4.4-3
2.
Tighten the two M2 x 3 screws to secure the fan to the logic upper assembly in
Figure 4.4-2
□
,5
3.
Check thermal pad is attached on the thermal module as shown in Figure 4.4-4 or
Figure 4.4-5
4.
Place the thermal module in the correct position on the motherboard.
5.
Tighten the three M2 x 3 screws according to the number sequence (8->7->6) indicated in
Figure 4.4-2
to secure the thermal module to the motherboard.
6.
For the W-LAN cable routing, tuck the W-LAN cable into the fan hook
□
,3, and W-LAN cable
connector insert the W-LAN card
□
,4. Finally, paste W-LAN mylar on the W-LAN
module
□
,5 as shown in
Figure
4.4-3
