dynabook SATELLITE C50-H, Maintenance Manual

Page: 62 / 161

NO.
CONT.ON 15 PAGE NO.14
Copyright (C) 2020 Dynabook Inc., All Rights Reserved.
No Test Media For ODD test. The test medium is not in the drive.
The medium has to include the test data file “CDDTEST0.DAT” in the
root folder, which is provided by WPETD CD.
You can use WPETD CD itself as a test medium.
IP Address cannot be acquired The IP address is not able to be obtained.
The LAN cable may not be connected.
No Intel PRO Set found For WIRELESS LAN test, Intel Pro Set utility is necessary to be installed in
the system.
No executable file The program file (executable file) for the test is missing.
Device not connected The device necessary for the test is not connected.
Device has a problem Some failure occurred in the device driver.
This Device is disabled The device has been removed.
This Device is currently stopped The device is in the STOPPED state.
Space Size Error There is not enough space for test in the test device
No partition of file There is no partition in HDD, USB or IEEE1394 disk, or no file exists in
HDD.
Item not support this device The test item not support this device (like LED & CPU Fan test items,
currently it only support YangPass20/30, so this status will be shown on
LED & CPU Fan test items if you run WPETD on other machines).

Test result … The test results to be shown on the screen are as follows:

PASS … Shows the current PASS count for the test.
3-3-4 Test Procedure
This section describes the general procedure for executing the test items.
1) Select the test items to run from Test Item and check it.
If you check or un-check “Check all Items”, you can select or deselect the all test items.
2) Set the LOOP count, and check or un-check Multitask and CPU Stress for the Aging tests.
4) Click the [START] button and the test starts.
5) If Multitask is checked, after all Non Aging tests are done, Aging tests you selected will run simultaneously.
6) If each test’s pass count reaches the “LOOP count” you set or if the [STOP] button is clicked, the test will terminate.
Result Explanation
-- This means that the test has not started yet or the test has been skipped.
OK The test was successful
NG The test failed