2 Troubleshooting Procedures
2-18
[CONFIDENTIAL]
dynaEdge DE200 Series Maintenance Manual (960-947)
2.4.1 Procedure 1
Message Check
When the power is turned on, the system performs the Initial Reliability Test (IRT) installed
in the BIOS ROM. The IRT tests each IC on the system board and initializes it.
If an error message is shown on the display, perform Check 1.
If there is no error message, go to Procedure 2.
Check 1 If one of the following error messages is displayed on the screen, press one of the
control buttons to start Windows OS and set the correct date and time.
If the following error message appears often at power-on, replace the battery pack
or RTC battery (if RTC battery is installed).
If any other error message other than below is displayed, perform Check 2.
(a) **** Date and Time reset to default ****
Press [F2] key to set Date and Time.
(b) **** Date and Time reset to default ****
Press any button to set the date/time in the OS.
(c) **** Date and Time reset to default ****
Press ENTER to set Date and Time.
(d) **** Date and Time reset to default ****
Press center button to set the date/time in the
OS.
Check 2 If the following error message is displayed on the screen, perform Check 3. If
another error message is displayed, perform Procedure 2.
Insert system disk in drive.
Press any key when ready....
Check 3 A device without any system information is installed and it may be designated as
the boot device. Remove the device and reboot the computer. At the reboot, press
F2
to display the BIOS setup screen. Set the correct boot device and repeat
Procedure 1. If any error still occurs or any device is not installed, go to Procedure
2.
Summary of Contents for dynaEdge DE200 Series
