dynabook dynaEdge DE200 Series, Maintenance Manual

Page: 190 / 248

4 Replacement Procedures 4.10 FINGER PRINT MODULE
4-58 [CONFIDENTIAL] dynaEdge DE200 Series Maintenance Manual (960-947)
Installing the FINGER PRINT MODULE
To install the FINGER PRINT MODULE, follow the steps below and refer to Figure 4-26.
1. Set the FINGER PRINT MODULE to the slot of the COVER ASSY.
2. Set the FP SUPPORT BRACKET to the COVER ASSY. (Insert the tips of the FP
SUPPORT BRACKET under the guides of the COVER ASSY.)
3. Secure the FP SUPPORT BRACKET with the following screw .
M2

3C S-THIN HEAD screw

1
4. Connect the FP FFC to the connector on the FINGER PRINT MODULE.
5. Arrange the FP FFC inside the lines on the SW BOARD and stick it on the INSU
PCB 5 BUTTON.
NOTE: Arrange the FP FFC as shown in the figure below.