USE R GUI DE
|
BL UE WAVE
®
F X -1 2 5 0
15
Operation
Start Up
1.
Verify all connectors are firmly plugged into the rear panel of the
BlueWave FX-1250 controller and emitter.
2.
On the rear panel of the controller, move the power switch to the
ON position (up direction).
3.
The start-up window (Figure 18) will appear for several seconds
as the system initializes.
4.
After starting up, the main window (Figure 19) appears.
WARNING!
Emitters must be installed correctly before power up.
If no emitter is installed, the controller is not operable. Power off
the controller and install at least one emitter.
5.
The system is now ready to have emitter parameters set.
Main Window Settings
In the main window, the operator can:
1.
Set each channel’s power and cure time.
2.
Start or stop each channel or all channels.
Figure 18.
Start-Up Window
Figure 19.
Main Window
1
2
3
4
5
6
7
8
9
10
