2
W W W . D Y E P A I N T B A L L . C O M
QUICK REFERENCE
AIR SUPPLY
The M3s should be operated using air/nitrogen gas only. This
air needs to be supplied at a regulated pressure of no more
than 850 psi.
GASSING UP YOUR M3S
Screw in your air system to the Airport and rotate the side
lever counter clockwise until the internal stop is reached.
TURNING ON YOUR M3s
Power up M3s marker
.
Note: Be sure to fully charge your M3s marker before first use.
To power on your M3s marker depress and hold the joystick located on the back strap
of the grip frame, for 2 seconds. The LED will illuminate and the boot up screen will be
displayed on the OLED.
The eye system is automatically powered on during boot up.
To turn the eyes on or off, press and hold the joystick downward for 2 seconds.
Blue:
Boot sequence
Red:
Breech is clear, no ball (eyes on)
Green:
Ball in breech, ready to fire (eyes on)
Blinking
Red:
Eyes are off
Blinking
Green:
Eye failure
HOPPER
To get the best performance out of your M3s, it is recommended that you use a motorized
loader. Preferably, the R-2™ Loader.
BATTERY CHARGING INSTRUCTIONS
The M3s marker uses a rechargeable battery.
To access the M3s’s charging port open the dust cover labeled USB on the upper left side
of the grip. Lift and rotate the cover out of the way.
In order charge your M3s marker, simply use any standard micro USB cable and power
supply. A micro USB cable is provided with the marker.
Plug the full size USB end of the cable into any standard power supply adapter (car
charger, wall charger, computer, etc.) See page 12 in manual for complete battery detail.
LED LIGHT COLOR INDEX-CHARGING
Blinking
Blue:
Charging up to 95%
Blinking
Green:
Charging up to 95% - 99%
Solid
Green:
100% charged
BASIC VELOCITY ADJUSTMENT
The velocity is CONTROLLED through the Hyper6s Pro™ regulator. The Hyper6s Pro™ is
preset from the factory at approximately 115 psi. This pressure setting should have the
marker shooting at about 285fps. Your paint-to-barrel fit will also have a noticeable effect
on your velocity.
You can adjust your velocity through the
Hyper6s Pro
™
regulator, located in the fore
grip. To adjust the velocity, insert a 3/16”
Allen wrench into the bottom of the fore
grip.
Turning the Allen wrench clockwise, or in,
will lower the output pressure, decreasing
the velocity. Turning the adjustment screw
counterclockwise, or out, will raise the
output pressure, increasing the velocity.
• A LOW BATTERY WILL NOT BE ABLE TO POWER BOTH THE ACE EYE AND
THE TRIGGER SWITCH, CAUSING ACE EYE FAILURE.
• IF THE BATTERY IS LOW, IT MAY NOT BE ABLE TO POWER THE SOLENOID
CORRECTLY. THIS WILL AFFECT THE M3S’S VELOCITY, CAUSING IT TO
BECOME INCONSISTENT AND/OR LOW.