19
W W W . D Y E P A I N T B A L L . C O M
HYPER6S PRO
™
GAS THRU REGULATOR
The M3s software tracks how many shots the marker has fired, and will
alert you when service is due. A red service icon will flash over the playing
screen. See service system on page 9 for more info.
NOTE: IT IS IMPORTANT TO KEEP THE SEAT AND PISTON FACE CLEAN OF ALL
DIRT AND DEBRIS. CLEAN THE SEAT AND PISTON FACE AND APPLY FRESH
GREASE EVERY 6 MONTHS OR 75,000 - 100,000 SHOTS, DEPENDING ON
PLAYING CONDITIONS.
HYPER6S PRO™ REGULATOR DISASSEMBLY INSTRUCTIONS
The Hyper6s ™ assembly is housed in a self-contained cartridge. A fouled Hyper6s ™
cartridge can be quickly removed for service. In most cases the only seal that needs to be
serviced is the regulator seat, located in the seat retainer. The rubber sleeve on the outside
of the Hyper6s ™ does not need to be removed to disassemble the Hyper6s ™.
• Using the rounded top edge of the hex wrench on your Dye multi-tool, or a coin
Unscrew and remove the Hyper6s ™ assembly cartridge from the bottom of the Hyper6s
™ fore grip housing.
• The Hyper6s ™ piston and spring may or may not come out with the cartridge.
If the piston and shim stack remain in the housing, use a pair of needle nose pliers
to gently pull the piston out.
CHANGING THE HYPER6S PRO ™ REG SEAT
• Use a straight pick to remove the black rubber retaining ring.
• Use a 3⁄16” Allen wrench, to unscrew and remove the brass Hyper6s™ seat retainer
assembly.
• Use a small pair of pliers to unscrew the cap of the seat retainer assembly.
NOTE: BE CAREFUL NOT TO LOSE THE PURGE POPPET AND/OR SPRING.
• From the top of the cap, use a 3/16” Allen to press the seat out of the cap.
• Press a new reg seat into the cap from the bottom.
• Lube the 010 O-ring, and screw the seat retainer assembly back into the cartridge.
• Install the black rubber retaining ring.
HYPER6S™ ASSEMBLY AND INSTALLATION
• Insert the piston through the large regulator spring.
• Apply Grease to the 015 Red Piston O-rings and bottom 3/8” of the piston shaft.
• Insert the piston shaft into the top of the Hyper6S™ cartridge.
• Make sure the spring sits evenly around the hex head.
• Be sure to grease the two 015 Red O-rings on the outside of the Hyper6s™ cartridge.
Take care when inserting the cartridge, not to cut or pinch outer O-rings on the
cross holes and threads in the Hyper6s™ fore grip housing.
• Install the assembled cartridge into the Hyper6s™ fore grip housing using the rounded
top edge of the hex wrench on your Dye multi-tool, or a coin.
• THE HYPER6S™ CAN HOLD A SMALL RESIDUAL CHARGE
OF GAS.
ALWAYS DISCHARGE THE MARKER IN A SAFE DIRECTION
TO RELIEVE THIS RESIDUAL GAS PRESSURE.
• EXCESSIVE DIRT AND DEBRIS CAN AFFECT THE
HYPER6S™’S PERFORMANCE AND INCREASE THE NEED
FOR SERVICE.
