PMC-700-X00 User’s Manual
DY 4 Systems Inc.
4-4
809789 Revision 2 December 2000
Installation Procedure - DY 4 Pentium Basecard
Before You
Begin...
Warning
This card uses components that are sensitive to electrostatic discharges. It
must be kept in its conductive package until just before the installation
begins. Remove the card from its protective package only at a grounded
workstation while wearing an approved grounding wrist strap. Avoid
touching any metal contacts on the card; static discharge can damage
integrated circuits.
Turn the power off before inserting or removing cards from the VME
chassis. Failure to do so could damage the card circuitry or cause personal
injury.
Unpack and
Configure the
Cards
Before installing the card into a chassis, ensure that you complete the pre-
installation tasks described in Chapter 2 of the Getting Started Manual for the
DY 4 basecard and in Chapter 2 of this manual.
Install the
PMC-700 on the
Basecard
If you received your PMC-700-X00 as a stand-alone product, install it on your
basecard using the DY 4 mounting kit.
Choosing a Slot
Location
Select Slot 1, the left-most slot in the VME chassis, if you want the card to be
the System Controller (SYSCON). If you intend to use another card as the
SYSCON, select the left-most unoccupied slot. All VME cards should be
installed in adjacent slots; leaving empty slots may cause problems with
interrupts and Bus Grant signals.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com