DVTEL Ariel EN-204, User And Installation Manual

Page: 26 / 112

EN-204 User and Installation Guide
14
To connect multiple PTZ cameras to the RS-485 port
Attach the camera to the RS-485 port according the following configuration:
Figure 13: Connecting Multiple PTZ Cameras
Assign a unique PTZ Address for each camera. The camera should be set with the same
serial address.
4.3 Resetting the Unit
The unit can be reset as follows:

Restoring Factory Defaults Using the Reset Button (page 14)

Power Reset by Removing the Power Supply or PoE cable (page 14)
4.3.1 Restoring Factory Defaults Using the Reset Button
A reset button is located on the unit’s rear panel. See Figure 2: EN-204 Rear Panel (page 4).
To restore factory defaults using the Reset button
Disconnect the power supply or Ethernet cable (when using PoE) from the unit.
Insert a small pointed object into the hole labeled RESET on the power connection panel of
the unit.
Connect the power supply or Ethernet cable to the unit while pressing and holding the
button.
Continue holding the button for 30 seconds.
Release the button. The unit restores factory defaults.
4.3.2 Power Reset
The unit can be reset by removing the power supply or Ethernet cable for PoE and then
reconnecting the unit.