SM-SG-2 Ev3/25062014
76
/
83
PROGRAMMING OF THE CONTROL UNIT
SPIDER PARAMETER PROGRAM
Getting Started:
-
Ensure the power on the SPIDER is off
-
Connect the programming cable between the NBB control unit (service plug) and your Computer
-
Set the switch on the cable in the direction OFF or O (depends on the cable version)
-
Switch on the power on the Spider
Operating with Spider Parameter Program:
-
Select the tab ”
Com-Port settings
” and select the com port you are using on your computer
-
When you select the tab “
Hydraulic servo
” you can read individual parameter from the \NBB control unit
(receiver)
-
You can change them and write them back to the NBB control unit. Use this function to set up parameters
for the hydraulic pump servo.
Service plug
Programming cable
Summary of Contents for ILD02 SG
