50
/
84
SM-SG-2 Ev3/25062014
6.20 REPLACEMENT OF THE WHEEL HOUSING
Dismounting:
-
Remove the housing cover
-
-
Remove the small chain sprocket ( Fig. 103)
-
Remove 2 countersunk screws no.1 (Fig. 103) , 3 capscrews no.3 (Fig. 104)
-
Remove the wheel housing
Mounting: (take the above steps in reverse order)
-
Clean wheel housing contact surface
-
Install all 2 countersunk screws no.1 with LOCTITE 243 and three capscrews no.3, for the middle one use a
new self-securing nut ( Fig. 103, 104)
-
Insert the wheel housing spring pins no.2 (Fig. 103)
-
Install the wheel shaft with sprocket and wheel hub see
-
Install the drive chain and small chain sprocket, secure the sprocket bolt with LOCTITE 243
-
Install the chain tensioning segment
-
Tension and lubricate the chain see
6.18 Adjustment and replacement of the wheel driving chain
-
Use a silicone sealant to seal wheel housing cover to the wheel housing and secure it.
-
Eventually secure screws of the housing cover with LOCTITE 243
Fig. 103
Fig. 104
1
1
2
2
use a silicone sealant
3
Summary of Contents for ILD02 SG
