ITVC Series – Intelligent Total Valve Controller IOM-ITVC-Basic-05
DVG AUTOMATION S.p.A.
Legal & Operative HQ: 29016 Cortemaggiore (Piacenza) Italy, Via G. Rossetti n° 2
Tel. (+39) 0523 255811; Fax (+39) 0523 255890;
Fully Paid In Capital: Euro 1.000.000,00=
ISO
9001, ISO 14001, OHSAS 18001
CERTIFIED
REA 167410 - VAT 01494460338
COMPANY SUBJECT TO MANAGEMENT AND COORDINATION BY G.I.V.A. S.P.A. WITH HEADQUARTERS IN RHO (MILAN), RECORDED UNDER NUMBER 02917180172 IN
MILAN'S REGISTER OF COMPANIES
www.dvgautomation.it
SHEET 8 DI 64
3 Introduction
This document,
IOM-ITVC-Basic
, is the Installation, Operation and Maintenance manual (
IOM
) of
ITVC
,
I
ntelligent
T
otal
V
alve
C
ontroller for pneumatic and hydraulic actuators. This manual includes only the instructions relevant to
BASIC version
of ITVC. The instructions of the
ITVC optional functions
(PST, Line Break, HPU control module,
Modbus protocol, HIPPS, Battery, etc.) are in the documents
Annex A,…,I
, of the above IOM.
DVG Automation will activate only the functions requested by the user application and needed to correctly control the
actuator.
This document does not contain the instructions relevant to the actuator controlled by the ITVC. The wiring and
hydraulic diagrams present in the next pages should be considered only as examples of application of ITVC.
Refer to documentation supplied with the actuator to view the specific mechanical, electrical and hydraulic functional
diagram and instructions.
This document is an integral part of the apparatus, which must be carefully read, understood and consulted
before use and must be retained for future reference
WARNING!
Do not install, operate, or maintain an ITVC without first being fully trained and qualified in valve,
actuator and accessory installation, operation and maintenance, and carefully reading and
understanding the contents of this manual, including all safety cautions and warnings. For any
questions regarding these instructions, contact the factory before proceeding.
4 General information
DVG Automation spa
products are engineered, manufactured and tested in accordance with the quality control system
complying with the international standard EN ISO 9001.
ITVC (Intelligent Total Valve Controller)
is an electronic device designed to control pneumatic and hydraulic
actuators.
DVG Automation will not be responsible for any possible damage or physical injury resulting from use in other than the
designated applications or by lack of care during installation, operation, adjustment and maintenance of the machine.
Such risks lie entirely with the user. Depending on the specific working conditions, additional precautions may be
requested. Considering that DVG Automation has no direct control over particular applications, operation or
maintenance conditions, it is operator’s responsibility to comply with all applicable safety rules. Contact urgently DVG
Automation in case of dangerous situations not considered in the manual. It is total responsibility of the operator to be
according to the local health and safety regulations.
5 Storage
Receipt
On receipt of the ITVC, always check any damage. Never install a damaged unit and report the detected defect to the
forwarding agent.
Packing
Ensure that adequate protections were secured during transport.
Handling and Storage
Ensure that principal holes on enclosure are occluded with a cap.
Storage temperature: -60°C ≤ T ≤ +85°C.
Summary of Contents for IOM-ITVC-Basic-05
Page 2: ......
