Dustcontrol 14124x, Original Instructions Manual

Page: 6 / 90

Part No 94153-G DC 11-Module - 39
Safety Considerations
Read all instructions before the machine/installa-
tion is commissioning.
The equipment must be installed and maintained
properly by quali
fi ed personnel who have study
this instruction. Dustcontrol does not take respon-
sibility for defective installation or maintenance.
Warning! When using electric machines, basic
safety precautions should always be followed to
reduce the risk of
fi re, electric shock and personal
injury, including the following:
1. Important!
No hot particles nor ignition sources are allowed
to be sucked into the unit. The machine should
not be used for explosives, unstable or pyrop-
horic particles or dust.
– WARNING!
Operators shall
be adequately instructed on the use of these
machines.
– WARNING!
This machine is for
dry use only.
– CAUTION!
This machine is for
indoor use only.
– CAUTION!
This machine shall
be stored indoors only.
2. Work area environment
Keep the area around the central unit clean.
Do not store or work with
fl ammable liquids or
gases near the machine.
3. Overload
If there is an alarm signal it should be care-
fully checked out to see that the machine is
un damaged. If there are any damaged parts
these should be repaired by a Dustcontrol
authorised service centre. Always follow the
regulations pertinent to the material you are
working with. Do not use the machine for pur-
poses that it is not intended for.
4. Bodily injuries
Warning - High negative pressure
Do not start the fan without having it con-
nected to the duct work. Never let the suction
come in contact with parts of the body, for
example a hand. The pump generates a high
negative pressure, severe injury may result.
Warning - Very hot exhaust air
Exhaust air can be very hot.
DC Green System: DC Green System works
with a sleep mode that has lower pressure.
When a tap is opened, the pressure is
fi rst low
and then increased 2-6 times at full operating
pressure.
5. Clamp risk
When emptying the container you normally
should put a trolley or moveable load bearing
item under the container before the eccentric
lock is released. Be aware of the clamp risk -
the container can be heavy.
Also, when transporting the whole machine,
especially when it is equipped with wheels,
please be careful. The unit is very heavy and
there can be be risk of an accident, especially
on sloping surfaces.
6. Electricity
When the unit is delivered without integrated
control panel and the panel is not then located
by the unit, an isolator should be
fi tted next to
the unit. Do not repair the electric components
yourself, get a quali
fi ed electrician. Faults may
cause injury. The electrical connections may
only be performed by a certi
fi ed electrician.
See also under section 8, ’Warning’.
7. Important measure
Never work with the dust extractor without fi rst
switching it off and locking the isolator.
8. Checking for damage
Check the machine regularly for damage. If
there are any damaged parts these should be
repaired by a Dustcontrol authorised service
centre.
If the supply cord is damaged, it must be re-
placed by the manufacturer, its service agent
or similarly quali
fi ed persons in order to avoid
a hazard.
9. Warning
Use only accessories and replaceable parts
which are available in the Dustcontrol catalo-
gue. When using non-genuine parts, especi-
ally
fi lters and plastic sacks, dust leaks could
occur which may be hazardous to health.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
EN
G
LI
S
H