Durr Dental Duo Tandem, Installation And Operating Instructions Manual

Page: 25 / 44

9.3 Draining the condensation
water
During transport, condensation water can accu-
mulate in the pressure tank due to changes in
temperature.
This also applies to compressors with a mem-
brane drying unit.
❯
At maximum tank pressure, slowly open the
condensate drain valve.
❯
Close the condensate drain valve as soon as
all of the condensation water has been blown
out.
9.4 Adjusting the rate of flow at
the pressure reducer
The pressure reducer regulates the rate of flow in
the system and adjusts it to the required operat-
ing pressure. In order to adjust the rate of flow air
needs to be extracted via a consumer.
❯
Activate the air consumer unit.
❯
Lift the rotary knob at the pressure reducer.
❯
Adjust the rate of flow via the rotary knob.
Turn the knob in the "+" direction to increase
the rate of flow.
Turn the knob in the "-" direction to reduce the
rate of flow.
❯
Press in the rotary knob until it engages and
cannot be adjusted.
+
-
1.
2.
3.
9.5 Monitoring the unit via the
network
The following requirements must be met in order
to monitor the unit on the computer:
– Unit connected to the network
– Current monitoring software installed on the
computer
Combining devices safely
– The overall safety of the unit and its main per-
formance features are independent of the net-
work. The device is designed for operation
independent of a network. However, some of
the functions are not available in this case.
– Incorrect manual configuration can lead to sig-
nificant network problems. The expert knowl-
edge of a network administrator is required for
configuration.
– The data connection utilises part of the band-
width of the network. Interactions with other
medical devices cannot be completely ruled
out. Apply the IEC 80001
‑
1 standard for risk
assessment.
– The device is not suitable for direct connection
to the public internet.
Network configuration
Various options are available for network configu-
ration:
ü
Automatic configuration via DHCP (recom-
mended).
ü
Automatic configuration via Auto-IP for direct
connection of unit and computer.
ü
Manual configuration.
❯
Configure the network settings of the unit using
the software or, if available, the touch screen.
Assembly
9000-610-72/30 1907V007 23
EN