24
24
24
ROLLER DOOR
FITTING HANDLE
•
Fit the handle (F) to the outside of the door using
the screws (P), nuts and washers provided
P
F
CENTRE LIFT LOCK
•
Raise the curtain until the lock corrugation is visible
above the door guides.
•
Install locking bar retainer (I) in line with lock
corrugation by pushing retainer towards door edge,
sliding the legs under the Nylofelt® and hooking
them over the curtain edge. Ensure lock bar
retainers sit squarely on door curtain
•
Fit faceplate (H) to outside of door where the hook
will latch onto curtain edge, then slide faceplate
as far to the right as possible. Use adhesive tape
on outside to hold in position
•
Attach the lock body (H) to the faceplate from the
inside, using the mounting screws and washers.
Do not over tighten the screws.
•
With the door in the closed position slide the end of the locking bars through the locking bar
retainers, and while holding the bars level mark the side of the guides.
•
Drill and fi le out a rectangular slot no longer than 25mm and no wider than 10mm. Ensure top of slot
remains in line with top of locking bar.
•
Slide bars through the guide slot, then back onto lock arms. Screw on securely using the counter sunk
screws (O). Ensure that locking bars do not protrude more than 20mm beyond guide when engaged in
locked position. It may be necessary to adjust the length of the bars.
•
Ensure a clean and dry guide surface. Wipe guide with clean rag.
•
Peel lining from lock bar cover (J) and position over hole. Check the movement of locking bar is free.
LACERATION
:
Wear appropriate gloves as
some edges of the door are very sharp.
It is easier to hook legs one at a time.
Legs
I
nylofelt
Legs go under
nylofelt and
snap over
curtain edge
Hook
This end fi rst
Lock corrugation
