Duratech HAYBUSTER 107C DRILL, Operating Instructions And Parts Manual

Page: 51 / 166

43 7 7 C / 1 0 7 C D R I L L S O P E R A T I N G I N S T R U C T I O N S
Section 6: Lubrication
All 77C/107C Grain Drills are completely serviced at the factory before shipping. However, the operator should make
a check of all grease fittings on the unit before beginning to operate it so as to become familiar with their location and
the correct service schedule.
Use only a high quality, multi-purpose grease when lubricating the unit. Make sure all fittings and the nozzle of the
grease applicator are clean before applying the grease. If any grease fittings are missing, replace them immediately.
Lubricating of all pillow block and flange-type self-aligning ball or roller bearings should be done slowly to help
prevent bearing seal damage. Use caution when using a high pressure, high volume gun.
Description Type Frequency No. Zerks
1. Swivel Wheel Pivot Grease 20 Hrs. 2
2. Torque Tube Bushings Grease 40 Hrs. 2
3. Universal Joints Grease 40 Hrs. 2
4. Square Drive Line Grease 40 Hrs. 2
5. Feed Wheel Shaft Grease 100 Hrs. 6
6. Roller Chains Oil Daily In Dusty Conditions
7. Tool Bar Bushing Grease 20 Hrs. 2
8. Lift Arm Bushing Grease 20 Hrs. 2
9. Lift Arm Grease 20 Hrs. 2
10. Drive Wheel Frame Grease 20 Hrs. 2
11. Packer Wheel Bearings and Coulter-Disk Bearings are Non-Relubable.
12. Cylinder Clevis Pin Grease 20 Hrs. 1
swivel wheel pivot
lubrication zerk