Duratech HAYBUSTER 107C DRILL, Operating Instructions And Parts Manual

Page: 31 / 166

23 7 7 C / 1 0 7 C D R I L L S O P E R A T I N G I N S T R U C T I O N S
one set of feed wheel space
adjustment bolts
bolt B
bolt A
feed wheel lugs, gauge and hopper are pressed
together. Tighten the eight bolts.
6. Recheck the feed wheel space adjustment.
7. Install the feed wheel covers.
The feed wheel space adjustment provides the proper clearance for the type of seed or fertilizer
being used.
FEED WHEEL SPACE ADJUSTMENT
1. Remove the feed wheel covers.
2. Loosen the eight bolts A and B. There are four sets
of bolts for each feed wheel - two on the outer end
of the hopper and six inside the hopper.
3. Select the proper space gauge using the wheel
space chart.
4. Install the proper space gauge as shown.
5. Slide the feed wheel toward the gauge until the
4.6 Feed Wheel Space Adjustment
feed wheel space
adjustment.
Large seeds require more space between feed wheel lugs and tank wall than small seeds to prevent cracking. Small
seeds require less space to provide an even flow. Therefore each seed listed in the feed rate chart, pages 28 to 31, shows
a required wheel space.
remaining bolt assemblies
control plate
center bolt assembly