Duratech HAYBUSTER 107C DRILL, Operating Instructions And Parts Manual

Page: 155 / 166

147
7 7 C / 1 0 7 C D R I L L S N G K - P A R T S A N D I N S T A L L A T I O N
Step 7. Place the (3) three assembled shafts with small paddles in tank. For upper agitator, insert second
agitator mounting plate (#17) between bearing and agitator mounting plates and bolt each together
using 3/8” x 1-1/4” carriage bolts, lock washer, and hex nuts. See pages 134-135.
Note: For a single bottom agitator kit, assemble a bearing spacer plate (#16) between bearing and
second agitator plate (#15).
Step 8. Kit contains 1-1/2” O.D. x 7/8” I.D. washers (#7). Add washers as needed to remove end play from
agitator shaft.
See pages 142-143.
Step 9. Bolt existing bearing and sprocket assembly (#A) (removed in step #1) to top end of agitator mount-
ing plate (#7) using (2) existing 3/8” x 1-1/4” socket head screws (#18). Assemble collar (#8),
bracket (#9), drive shaft stub (#10) and sprocket (#12) as shown, bolt above assembly to the bottom
end of mounting plate (#7) using (2) 3/8” x 1-1/4” socket head screws (#18).
See pages 142-143.
Step 10.
Bolt completed assembly (step #9) to end of tank using existing 3/8” x 1-1/2” hex head machine bolt
in top end, 3/8” x 1” (#20) hex head in bottom end along with wood block idler mount (#5).
See pages 142-143.
Step 11. Bolt bearing and sprocket assembly (#16) with 24 tooth sprocket to upper agitator shaft using 3/8” x
1” (#20) hex head machine bolt in top slot and 3/8” x 1-1/2” (#19) hex head machine bolt in bottom
hole with flat washers and hex nuts. See pages 142-143.
Note: Step #11 used only with a dual agitator.
Step 12.
Loosen sprockets and bearings on 1” drive shaft (#30) and shift to the right to allow enough shaft to
accommodate second drive sprocket. Align all respective sprockets and secure.
See pages 142-143.
Step 13. Install both drive chains (#1 & #2). See pages 142-143.
Step 14.
Install wood block idler (#4) using 3/8” x 2-1/2” (#21) hex head machine bolt. Adjust chain tension.
See pages 142-143.
Step 15.
Remove existing idler sprocket and spacer and install idler sprocket mount (#6) and existing idler
sprocket using ½” x 1-1/2” hex head machine bolts. Adjust chain tension. See pages 142-143.
Step 16.
Install existing shield (p.n. 8400243) for single agitator or new shield (p.n. 8400246) for double agi-
tator using existing bolts. See pages 142-143.