Duran Electronica EUROSONDELCO, Installation Manual

Page: 10 / 96

34
© 2005 DURAN ELECTRONICA S.L.
All rights reserved · www.duranelectronica.com
34
ENGINEER CODE
The “Engineer Code” is a password that restrict the access to the system programmed parameters to those people not authorized
for its programming, checking and maintenance. Default password is 66666. It is obtained by pressing five times
ENTER .
We recommend to customised this password. You will need a 5 number code bearing in mind the following table of push
buttons and numbers correspondence.
Push buttons Numbers
ON / OFF 1
ACOUSTIC INHIBITION 2
VENTILATION 3
PROGRAMMING 4
FORWARD 5
ENTER 6
To change the code, proceed as follows:
1. Press PROGRAMMING
Insert the new code that automatically will be the new Engineer Code.
SYSTEM OVERHAUL
No System Overhaul is programmed by default. If you want to program this warning proceed as follows:
1. Press PROGRAMMING
The number of months regarding the overhaul period will be displayed -from 0 to 12-.
2.
Press
FORWARD
to select the overhaul period -in months-.
3.
Press ENTER to memorised.
Once the programmed period has ended, the message “Rev” will be displayed and an acoustic will go off. This can be inhibited
by the user.
RESET OF SYSTEM OVERHAUL
To reset from the display the System Overhaul Warning “Rev” and start a new cycle once an authorised technician has carried
out the installation checking, proceed as follows:
1.
Press PROGRAMMING .
“OK” will be displayed and a confirmation acoustic will go off.
ACOUSTICS INHIBITION
This menu allows to choose if the events: Ventilation, Alarm and Saturation Levels -equipment bottom of scale- can go off an
internal acoustic. This function is specially usefull when the Control Unit has been installed in a place where people are working
in order to avoid any inconvenience caused by the normal functioning of the Control Unit.
The acoustics can not be programmed independently. They all must be ACTIVATED or DEACTIVATED.
They will apperar activated by default. If you want to deactivate them, proceed as follows:
1.
Press PROGRAMMING