25
Owner's Manual for
DUKE RCO Speed Oven
WARNING
To avoid electrical shock, which can cause severe personal injury or death, do not remove outer panels at any
time. Only an authorized service agent may remove the outer panels.
An authorized service agent MUST inspect the equipment annually.
Record all inspections and repair for future reference.
Problem
Possible Cause
Oven will not power up
•
Confirm that the oven is plugged into dedicated circuit.
•
Confirm that the oven is on grounded circuit. (Contact a
licensed electrician to confirm)
•
Check the fuse or circuit breaker.
•
If the problem persists, contact an authorized service agent.
Oven does not accept keypad
entries.
•
Make sure that the oven is on and preheated to the Set
Temperature.
•
Open and close the oven door. Press keys again.
•
Switch off the oven for 1 minute, turn on and press keys again.
•
If the oven is in standby, close the door first then press
CONTINUE.
•
If the problem persists, contact an authorized service agent.
Oven malfunctions or shows
“
ERROR
”:
The oven control is equipped with a self-diagnostic system. The
self-diagnostic system alerts you if there is an error or problem.
When the electronic controller indicates a problem, follow the
steps listed below.
1. Record the error.
•
“Fan Error” indicates a problem with the convection
blower motor circuit.
•
“Mag Error” indicates a problem in one or both of the
magnetron circuits.
•
“Probe Error” indicates a problem with the cavity
temperature probe.
•
“Door Ajar” indicates a problem with proper closure of the
oven door.
2. Unplug the oven, wait 1 minute, and then plug in the oven.
Disconnecting the electrical supply may eliminate the error
code.
3. If a Fan Error or Probe Error persists, disconnect the oven
from the power supply and contact an authorized service
agent. Do not reconnect the power cord to prevent hazards.
4. The oven can still be used with a recurring Mag Error,
however, microwaves may not work. It is recommended to
contact an authorized service agent.
TROUBLESHOOTING
