SE
CTION 3
| I
NST
ALLA
TION
Infinity™
Series Servo Ultrasonic Press Systems QUICK START GUIDE
13
Unpacking the System
The system has been assembled and packaged at the factory for shipment. Depending on the system, components may be
packaged in multiple crates or boxes.
The press is secured to a wooden pallet and covered with a wooden crate. Components inside the crate are secured with
screws, metal bands, and additional packing materials to give reinforcement where needed. Before unpacking the press,
use mechanical assistance to move it close to the location where it will be installed.
To unpack the press:
1.
Carefully remove the wooden create from the pallet to expose the contents.
2. Remove the packing material, and temporarily set aside any other system components, leaving the press on the pallet.
3.
Inspect the assembly for any damage before placing it in position.
Placement on Workbench
Do not lift the press by hand. Use mechanical means to put the press into place.
The workbench onto which the press will be placed must be capable of supporting the weight of the system. The table
below lists the weights of various press models, excluding the horn. It is recommended that the load rating of the workbench
be at least 50% larger than the weight of the system.
Model
Description
Weight
(Excludes horn and generator)
lbs
kg
43NTLA on 43NSLA
15K Infinity
TM
System (press and HMI)
433
197
43NTME on 43NSME
20K Infinity
TM
System (press and HMI)
400
182
43NTLA
15K Infinity
TM
Thruster only (without base, column, or HMI)
156
71
43NTME
20K Infinity
TM
Thruster only (without base, column, or HMI)
125
57
Table 3-3
Model Weights
