Infinity™
Series Servo Ultrasonic Press Systems QUICK START GUIDE
32
SE
CTION 4
| C
ONTR
OLS
AND
I
NDICA
TORS
Figure 4-44
Fixture Leveling Screws
6.
Change the Speed to Low, then move the press down until a light amount of pressure is applied to the parts
(approximately 10-20 lbs. [40-90 N]).
7.
Turn the four jack screws as shown in Fig. 4-44 clockwise until a slight resistance is felt.
8.
Change the Jog Direction to Up, then activate the operate switches to move the horn up until there is no force on
the parts.
9.
Using carbon paper or a feeler gauge, determined which side of the fixture must be raised to make the part level
with the horn, then turn the corresponding jack screw(s) clockwise. If needed, move the horn up or down to aid in
this step.
10.
Tighten the hold-down cap screws by turning them clockwise until firm resistance is felt.
11.
return the press to the home position as follows:
a.
Select Exit.
b.
Press No when asked to set the position.
c.
Follow the instructions on the screen.
