Infinity™
Series Servo Ultrasonic Press Systems QUICK START GUIDE
24
SE
CTION 4
| C
ONTR
OLS
AND
I
NDICA
TORS
8.
Place the ultrasonic stack module into the press by sliding it in as shown in Fig 4-19. Push it all the way in so that the
booster mounting block is inserted onto the pins in the press.
9.
Tighten the (4) screws shown in Fig 4-20.
10.
Pull transducer clamp bar straight out as shown in Fig 4-21 by arrow 1, then rotate it 180 degrees clockwise, and push
it back in as shown by arrows 2 and 3.
Figure 4-22
Tighten Clamp Bar
Figure 4-23
Transducer Door Pins
Figure 4-24
Latching the Door
11.
Tighten the (2) clamp bar screws shown in Fig 4-22.
12.
Take the transducer door removed earlier, place the hex wrench inside as shown in Fig 4-23.
13.
Align the pins on the door with the bottom of the slots on the press as shown in Fig 4-23, then push the door against
the press.
14.
Slide the door up as shown in Fig 4-24 until a click is heard, which indicates it is latched.
Figure 4-19
Transducer Stack Module
Figure 4-21
Transducer Clamp Bar Clamp
Figure 4-20
Module Clamp Screws
