12. Setting the Optional Equipment
12.1 Draw-off Device and Bundle Clamp
The draw-off device 4 (Order no. 0794 000701) conveys the finished
sewing piece out of the machine so that it hangs down on the bundle
clamp 6 (Order no. 0794 002201).
Caution Risk of Injury !
Turn the main switch off.
Set the draw-off device only with the main switch turned off.
–
Loosen the four mounting screws on the clamping piece 7.
–
Align the spar 5 so that the transport rollers 1 and roller 2 lie
vertically above each other.
The transport rollers 1 must move up and down unhindered. The
swinging-up of the cover hood should not be hindered.
–
Set the height of the spar 5.
The lowered transport rollers 1 must touch roller 2.
–
The angle 3 can be swung out.
Therefore there must be a certain clearance between the angle 3
and the draw-off device.
Align the height of spar 5 appropriately.
–
Tighten the mounting screws on the clamping piece 7.
–
Set the lowering speed of the transport rollers 1 at the one-way
restrictor valves 8 and 9.
The lowering movement should occur rapidly, but not with a jerk.
–
Set the start timing of the transport roller turning movement.
During the lowering movement the transport rollers 1 must begin
their turning movement approx. 3 mm before reaching the roller 2.
Set the switch on the inside of the draw-off device accordingly.
Note:
For extremely heavy materials an earlier start timing for the turning
movement may be necessary.
1
2
3
4
5
6
7
8
9
72
