3.2 Aligning the Folder to the Center of the Pocket Opening
When properly mounted the folder can be aligned from the
measurement line 17 to the center of the pocket opening.
Dependent on the width of the folder sole 19 the dimension x can be
established. With the aid of this dimension the folder can be aligned to
the center of the pocket opening 18 and parallel to the measurement
line 17.
–
Subtract the piping width a and half of the
needle clearance NA from the dimension 125 mm.
Example from the sketch: 125 mm - a - 1/2 x NA x
125 mm - 5 mm - 1/2 x 12 mm = 114 mm
Piping widths and needle clearances for other folders can be found
in the Operating Instructions.
Caution Risk of Injury !
Turn the main switch off.
Align the folder to the center of the pocket opening only with the main
switch turned off.
–
Loosen screws 16 slightly.
–
Align the folder sole parallel to the measurement line 17 with the
aid of a measuring stick.
–
Tighten screws 16.
–
Loosen clamping screw 14 slightly.
–
Set the clearance x (in the example x = 114 mm) between
measurement line 17 and the left edge of the folder sole 19.
For this slide the folder sideways.
–
Tighten clamping screw 14.
18
19
17
13
