3. Folder
For the unimpaired transport of the material and a flawless fabrication
of the pocket opening, the folding and cutting tools, as well as the
marker lights, must be aligned to the center of the pocket opening.
The incision of the center knife is seen as the center of the pocket
opening.
The measurement line 2 was traced on the machine plate at the
factory.
It runs parallel to the center of the pocket opening, that is, to the
center knife incision at a clearance of 125 mm.
By proper mounting of the folder 1 it can be aligned from the
measurement line to the center of the pocket opening
(see Chapter 3.2).
Proper mounting of the folder:
–
The folder 1 is pushed up onto the clamping piece 5 until it touches.
–
The pin 3 catches in slot 4.
1
2
3
4
5
1
10
