15
INSTALLATION
8) ELECTRICAL CONNECTION
The electrical connection must be made in
compliance with the standards and legal
provisions in force.
Before making the connection, ensure that:
- the voltage matches the value shown on the
specification plate and the section of the wires of
the electrical system can support the load, which
is also indicated on the specification plate.
- The socket or system has an effective earth
connection in compliance with the standards and
legal provisions currently in force. We cannot
accept any responsibility for failure to observe
these provisions.
When the appliance is connected to the power
supply via socket:
- fit a standard plug suited to the load indicated on
the label to the power cable “C” if necessary.
- Connect the wires in compliance with the diagram
in fig. 11, ensuring that the following are observed:
letter L (phase) = brown wire;
letter N (neutral) = blue wire;
earth symbol
= green-yellow wire.
- The power cable must be positioned so that it
does not reach an temperature of 90 °C in any
point.
- Do not use reductions, adapters or shunts for the
connection, as they could make false contacts
causing hazards due to overheating.
- The socket must be accessible after fitting.
When the connection is made directly to the
electricity main:
- insert an omnipolar switch between the appliance
and the power network, in a size suited to the load
of the appliance, with a minimum aperture
between contacts of 3 mm.
- Remember that the earth cable must not be
interrupted by the switch.
- The electrical connection may also be protected
with a highly sensitive differential switch.
We strongly recommend that you connect the
appropriate green-yellow earth wire to an efficient
earth system.
Before performing any service on the electrical
part of the appliance, it must absolutely be
disconnected from the electrical network.
The manufacturer declines all responsibility for
damages suffered by people and items due to
failure to observe the aforementioned indications,
or deriving from interference with a single part of
the appliance.
WARNINGS:
all our products are conform with the
European Norms and relative amendments.
The product is therefore conform with the
requirements of the European Directivesin
force relating to:
- compatibility electromagnetic (EMC);
- electrical security (LVD);
- restriction of use of certain hazardous
substances (RoHS);
- EcoDesign (ERP).
IMPORTANT!
The appliance must be installed following
the manufacturer's instructions. The
manufacturer will not be liable for injury
to persons or animals or property
damage
caused
by an incorrect
installation.
If the installation requires modifications
to the home's electrical system or if the
socket
is incompatible
with
the
appliance's plug, have changes or
replacements
performed
by
professionally-qualified
person.
In
particular, this person must also make
sure that the section of the wires of the
socket is suitable for the power absorbed
by the appliance.
FIG. 11
