12
INSTALLATION
3) INSERTING THE HOB
After removing the outer and inner packing of the
various mobile parts, ensure that the hob is
undamaged. If you are in any doubt, do not use
the appliance and contact qualified personnel.
The packing elements (cardboard, bags,
polystyrene, nails must not be left within the
reach of children as they are potential sources
of danger.
Make a hole in the worktop to accommodate the
hob, using the measurements indicated in fig. 7,
ensuring that the critical dimensions of the space
in which the appliance must be installed are
observed (see fig. 8).
The appliance must belong to class 3 and is
therefore subject to all the indications of the
standards for such appliances.
The appliance can be installed with just one lateral
wall (to the right or left of the hob), higher than the
hob and positioned at a minimum distance as
described in the table below.
3A) CYLINDER HOLDER COMPARTMENT
The dimensions of the cylinder compartment have to
permit the easy loading and unloading of the cylinder.
For an efficient aeration is necessary to make some
small openings in the furniture, as per fig. 9/A
and 9/B.
The cylinder holder compartment must have the
following characteristics:
- resistance to a load.
- No fitment of the cylinder directly on the floor are
allowed.
- The cylinder equipped with governor must be set or
take off from the compartment in a easy way.
- The cylinder cock must be easily accessible.
- The flexible tube musn't be in contact with sharp
edges.
- The cylinder holder compartment and the different
parts of the unit, where the burners are fit, musn't be
in touch inside.
- The aeration openings musn't be occluded when the
unit is installed.
The appliance belongs to class 3 and is therefore
subject to all the provisions established by the
provisions governing such appliances.
IMPORTANT:
a perfect
installation,
adjustment
or
transformation of the cook top to use other
gases requires a QUALIFIED INSTALLER: a
failure to follow this rule will void the
warranty.
FIG. 9/A
FIG. 9/B
CAUTION: do not place the glass directly
on the unit. The bottom of the hob must
rest on the unit.
