Light control
Headlight control
This function allows you to reduce current
consumption from the battery, by automatically
managing headlight switching-off.
Upon Key-On, low and high beams are Off. Upon
engine starting, the low beam will automatically turn
on; from this time onwards, "standard" operation will
be enabled: you can switch from low to high beams
(using button (3)) or make a "FLASH" (using button (3)).
If engine is not started upon Key-On, lights can
nevertheless be enabled by pressing the button on
high / low beam left-hand switch (button (3)); if
pressed once, low beams will be enabled; from this
time onwards, this button can be used to enable (and
disable) high beams (if engine is not started within 60
seconds, the active low or high beam will be
disabled).
If the headlight was turned on before starting the
engine with the procedure described above, the
headlight will turn off automatically when starting the
vehicle and will turn ON again when the engine has
been completely started.
3
Fig. 74
130
Summary of Contents for Diavel 2014
