WFQT130005
5
V4.1B
STEP
3
Mount the System Head
1
Choose an easy-to-access area under the sink to mount the Filter System.
NOTE: To allow adequate space for filter changes, allow a minimum clearance of 4-6” below the QuickTwist
®
Filters. The Filter System
must be mounted in a vertical position.
NOTE: Mount the Filter System to a solid cabinet wall or wall. If a solid surface is not available, use hollow-wall anchor bolts or toggle
bolts (not included) to secure to the wall.
2
Remove cartridge from system head by turning from right to left.
3
Remove the cap from the top of the System Head
A
. Using the Built-in Bracket on the back of the System Head, mark the holes for
the Mounting Screws
C
on the wall surface.
4
Using a 1/8” drill bit, drill two pilot holes for the Mounting Screws. Insert Mounting Screws into the wall with a Phillips screwdriver,
leaving approximately 3/8” of each Mounting Screw exposed.
5
Hang the System Head on the eyes of the bracket and replace the System Head cap.
STEP
4
Install 1/4” Plastic Tubing for Water Supply Line from
Kitchen Faucet Adapter to System Head Inlet
1
Determine the length of 1/4” Plastic Tubing
L
that will be necessary to connect the System Head Inlet to the Kitchen Faucet
Adapter
H
. Make sure to allow enough Plastic Tubing to prevent kinking in the line.
2
Cut the 1/4” Plastic Tubing squarely on both ends with a utility knife, making sure not to crimp the Plastic Tubing during cutting.
3
Wet one end of the 1/4” Plastic Tubing with water and push it into the Kitchen Faucet Adapter approximately 5/8” until it stops.
NOTE: Do not bend or crimp 1/4” Plastic Tubing when inserting.
4
Wet the other end of the 1/4” Plastic Tubing with water and push it into the System Head Inlet approximately 5/8” until it stops.
NOTE: The 1/4” Plastic Tubing does not need to be disconnected for general routine maintenance and filter replacement. However,
Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to the Filter System and press in the grey collar
around the fitting while pulling the Plastic Tubing out with the other hand.
Be sure that all electrical appliances and outlets are turned off at the
circuit breaker before working in cabinet area.
Please wear safety glasses to protect
eyes when drilling.
CAUTION
WARNING
X
X
WFQT130005
3
X
X
WFQT130005
X
X
WFQT270005
4
X
X
WFQT130005
3
4
3
2
A
4-6”
INLET
OUTLET
INLET
OUTLET
HOT WATER
VALVE
1/4” PLASTIC
TUBING
COLD WATER
VALVE
5/8”
C
C
H
L
3
