DTS X BRICK, User Manual, Page: 26 / 39

User Manual Ver. 1.04 24 di 35
X BRICK
e.g. , when using the unit in “Chase” (23 DMX channels) (Default) mode, set the following addresses on the
light desk as shown below:
Projector 1 A001
Projector 2 A024
If you want to select the next projector, just add “23” to the former DMX address
Projector 3 A047
….. A….
Projector 6 A116
12.3 Setting Up the DMX Address
1 Press the UP and DOWN key until you reach the desired DMX address. The numbers on the display will
start flashing (new DMX address hasn't yet been set).
2 Press ENTER to confirm your selection. The numbers on the display will stop flashing; the projector is now
set to the new DMX address.
TIP : if you keep pressed down the UP or DOWN keys, address scrolling will be quicker allowing thus for a
faster selection.
13 Updating the Firmware
In order to update to the latest firmware release of the SYNERGY 7 PROFILE, you will need:

DTS firmware uploader dongle (code 03.LA.206).

“DTS Firmware Upgrade Utility v.2.02” program installed on PC (Windows OS).

Latest firmware release available for the SYNERGY 7 PROFILE.
Updating to the latest firmware release:
To perform the update, please follow the procedure as described below:
1 Connect the DTS Firmware Uploader Dongle to a spare USB port on the PC.
2 Connect the unit’s DMX IN to the DTS Firmware Uploader Dongle’s DMX OUT with a standard DMX cable
and turn on the fixture.
3 Send the new firmware release into the unit by using “DTS Firmware Upgrade Utility v.2.02” program. At
the end of the procedure, the unit will commence a reset.
For more information, please refer to an authorized DTS service center.