DTS X BRICK, User Manual, Page: 20 / 39

User Manual Ver. 1.04 18 di 35
X BRICK
10 Maintenance
D.T.S. Illuminazione Srl’s products are of higher quality and design, therefore must be treated with care.
The following recommendations will help you keep your warranty intact, to make the best possible use of the
product, and to maximize their lifespan:
Do not use the product (or products) before carefully reading this manual.
Failing to comply with the instructions on this manual may cause injury or damage.
Periodically check the status of the cables. Make sure the cables are not damaged.
Ensure that a sufficient air flow is given to the device, removing any obstruction that may prevent proper
cooling of the product.
DO NOT use aggressive chemicals, solvents or abrasive detergents to clean the product. For the body, use a
wet cloth. For the front panel, use window cleaning products.
For the best duration of the product painting, periodic washing with fresh water is recommended. Cleaning
frequency varies in accordance with the salinity present in the place of installation Avoid high pressure water
jets.
If the product does not work the way it is meant to, please contact the nearest authorized support center or
refer directly to D.T.S. Illuminazione S.r.l.
Do not try to repair the product yourself. In case of need, please contact the nearest authorized support center
or refer directly to D.T.S. Illuminazione Srl.
10.1 Front Glass Cover
Even a fine layer of dust can substantially reduce the luminous output of the luminaire.
Regularly clean the front glass cover using a soft cotton cloth, dampened with a dedicated glass cleaning
solution.
10.2 Fans and Air Passages
The fans and air passages must be cleaned approximately every 6 weeks.
This time period will of course vary depending on the conditions in which the projector is operating.
Suitable instruments for performing this type of maintenance are a brush and a common vacuum cleaner or air
compressor.
If necessary, clean the fans and air passages more frequently than suggested.
10.3 Periodic Check-ups
• Mechanical parts
Periodically check all mechanical parts and gaskets. Please refer to an authorized DTS service center if
maintenance is needed.
• Electrical components
Check all electrical components for correct earthing and proper connection of all connectors.